Judge Awards $2 Million to Zimmer Hip Implant Plaintiff

Joseph Osborne, Jr., of Osborne & Associates in Boca Raton, Fla
Joseph Osborne, Jr., of Osborne & Associates in Boca Raton, FL.

Medical device manufacturer Zimmer Inc. has been ordered to pay more than $2 million to a New Mexico man for a defective Zimmer hip implant with an “unreasonably dangerous design,” following a two-week bench trial.

“This is the first case we know of that has gone to trial in the country, and a growing number of these are going to court,” said Joseph Osborne, Jr., of Osborne & Associates in Boca Raton, Fla., who represents medical device plaintiffs around the country. Osborne tried the case with Randi McGinn and Allegra Carpenter of McGinn, Carpenter, Montoya & Love, P.A., of Albuquerque, N.M.

The product in question is Zimmer’s dual modular hip implant, the M/L Taper Hip Prosthesis with Kinectiv Technology (“MLTK”) and a cobalt-chromium head.

In a 27-page decision, New Mexico Judge Nan G. Nash ruled that the defective design and insufficient testing caused likely permanent harm to the plaintiff, resulting in “metallosis,” or a buildup of cobalt debris harming the hip joint and contaminating blood.

“It is never appropriate to design a hip implant system that would create an unreasonable risk of injury to the health or safety of a patient,” Nash wrote, ruling for the patient on grounds of strict products liability.

The case is McDonald v. Zimmer Inc. and Zimmer Holdings, Case No. D-202-CV-201304060, Second Judicial District, New Mexico County for Bernalillo.

Separately, Zimmer is facing 466 lawsuits in MDL 2158 supervised by U.S. District Judge Susan D Wigenton in federal court in New Jersey. IN RE: Zimmer Durom Hip Cup Products Liability Litigation.

Two corrective surgeries

In February 2010, Michael Brian McDonald, an Albuquerque economist then in his sixties, was suffering right hip pain that was preventing him from his usual tennis and golf. That June, McDonald received the MTLK implant.

Initial recovery went well, but by May 2011, McDonald suffered from hip and groin pain and loss of flexibility, resulting in two corrective surgeries that October and November, during which the doctor implanted two new prostheses and replaced the cobalt-chromium head with a ceramic head.

After a lengthy recovery, McDonald sued and the case went to bench trial before Judge Nash December 12-23, 2016, in the Second Judicial District Court in Albuquerque.

In her March 31 ruling, Judge Nash wrote that the ordeal has forced McDonald to a permanent course of antibiotics, an end to golf and tennis, and the likelihood of a recurrent infection.

“It is more probable than not that Plaintiff will need a third, more complicated revision surgery in the future,” Nash wrote. “This surgery will cost approximately $250,000 and will involve removal of all of the implant components for a period of 2-3 months to try and kill the infection, during which Plaintiff will be wheelchair bound. If the infection can be successfully eradicated, another hip prosthesis will be implanted, necessitating the same type of physical therapy and recovery period as the first two revision surgeries.”

Product defect

The judge traced the product defect to Zimmer’s testing its components in isolation, but not their interactions together, which would have determined their potential harm.

“In designing the MLTK, Defendants knew that the use of dissimilar metals can result in a higher potential for corrosion and that wear debris from a junction of two dissimilar metals had been documented to be toxic and harmful to the human body,” she wrote.

In determining the damages of $2.027 million, Judge Nash apportioned it into $1 million for past and future pain and suffering, $480,000 for lost enjoyment of life, and the rest for past and future medical expenses, lost household services, and out-of-pocket expenses.

 


Share this Post: